ip address dhcp ! or request IP address.description T1 circuit #hsqw1234 from CenturyLink.interface ATM0/0/0 ! make changes to ADSL HWIC.interface Serial0/1/0 ! make changes to T1 HWIC.interface ge0/0/0 ! make changes to GigabitEthernet.

do show interfaces fe0/0 ! DO run EXEC command in configuration mode.

interface fe0/0 ! make changes to FastEthernet.

enable ! password usually required to enter privileged mode w/ #prompt.

show file systems ! list memory (Flash, NVRAM).

show hardware ! list memory (Flash, NVRAM).

! # : Comment can be a exclamation mark number sign, pound, hash, octothorpe, colon or semicolon.

ROMmon tftpdnld -r command copies the image from the TFTP server to the router with the -r telling it to write over the old images and files for a new Compact Flash. SYSTEM INIT: INSUFFICIENT MEMORY TO BOOT THE IMAGE! IOMem configured: 33554432 bytes, IOMem allocated: 10485760 bytes Memory low adjusting PMem and IOMem sizes. Use the router with reduced functionality until you get more memory. May cause the memory requirement to decrease, and may allow you to at least The difference between Memory required and Memory available is the additional INSUFFICIENT MEMORY TO LOAD IMAGE! YOU BE SHORT 5,864,308 bytes Memory required: 140082036 bytes, Memory available: 134217728 bytes

TRY Erasing by reformatting as Class C flash file using Microsoft 16-bit File Allocation Table (FAT16) on PC → no PC with Compact Flash reader!Įrase using the C2851: 2851# erase flash:Ĭopy usbflash1:Cisco/ flash:Ĥ7454756 bytes copied in 238.104 secs (199303 bytes/sec)Ĭlass B is the low-end file system (LEFS)ġ 47454756 ġ25184K bytes of ATA CompactFlash (Read/Write)Īlso had too small a memory size for Flash to store IOS, config & VLAN.dat Usbflash0: contains unexpected values in partition table or boot sector. Program load complete, entry point: 0x8000f000, size: 0x2d41884 Wrong IOS image for 1841 on ATA Compact Flash pulled from a big switch Loadprog: error - Invalid image for platformĢ 10022720 -rw. Program load complete, entry point: 0x8000f000, size: 0xcb80 Onboard SDRAM: Size = 128 MB : Start Addr = 0x00000000Ĭurrent Memory configuration is: Voice Data VLANs Sub-interfaces CUCME Configure Extensions CUCME Web Interface Communications Manager Express CUCME HTML GUI Telephony Service C2800 NM About Splash Page Internet Explorer FXO FXS Cisco Meraki Viptela SD-WAN Cisco SMB Switch Portfolio2018 ROMmon Mode rommon # > meminfoĬurrent Memory configuration is:

Cucm boot.bif download